Portable Solar Panel

Solar Lantern Manufacturers, Solar Light Manufacturers, Solar Lights China
Visit http://www.cn-solargardenlights.com for details

Battery board assembly: before assembling the battery plate bracket and transported to the nearby light pole base, the battery plates with screws on the shelf, according to the requirements of the line and tandem junction solar panels, wiring test after the close finish, ensure that the voltage Annexed installation requirements.
Normal weather conditions: 12V battery system board system test voltage can not be lower than 18V, 24V battery system board test voltage can not be lower than 36V. If less than the voltage required to check whether the board meets the requirement.
Also, pay attention to the following points during the installation process:
1, LED lights should be installed on a sunny day, rainy day installation if, after lighting not only consumes the charge, will not meet the design requirements.
2, installing the day should not be lit. Many engineering companies rush to see the lighting effects, the installation will finish the night lights. Because the new battery is not fully charged at the factory time, if installed on the lights, it is less than the design of the rainy day.
The correct approach is, after the installation is complete, connect the controller, but does not take the load, the next day after day electric charge, the evening followed by a load, so that the battery capacity can reach a higher level. Of course, doing so will increase the part of the labor costs.